HP A9890A HP A9891A Smart Array 6404 Controller Installation Guide - Page 12

Smart Array 6404 Controller HP-UX Installation Verifying the Installation Verifying the Installation After the system reboots, verify that the installation was successful by following these steps: Step 1. Issue the swlist command: swlist If the Smart Array Controller is installed correctly, the generated output will look similar to the following: When running HP-UX 11i v1 the generated output will look like this: RAID-01 B.11.11.03 RAID SA; Supptd HW=A7143A/A9890A/A9891A When running HP-UX 11i v2 the generated output will look like this: RAID-01 B.11.23.02 RAID SA; Supptd HW=A7143A/A9890A/A9891A When running HP-UX 11i v3 the generated output will look like this: RAID-01 B.11.31.01 RAID SA; Supptd HW=A7143A/A9890A/A9891A Step 2. Issue the ioscan -kfnd ciss command: ioscan -kfnd ciss If the Smart Array Controller software is installed correctly, the generated output will look similar to this: # ioscan -kfnd ciss Class I H/W Path Driver S/W State H/W Type Description ext_bus 4 0/3/1/0/4/0 ciss CLAIMED INTERFACE PCI-X SmartArray 6404 RAID Controller /dev/ciss4 ext_bus 7 0/3/1/0/5/0 ciss CLAIMED INTERFACE PCI-X SmartArray 6404 RAID Controller /dev/ciss7 ext_bus 6 0/5/1/0/4/0 ciss CLAIMED INTERFACE PCI-X SmartArray 6402 RAID Controller /dev/ciss6 If the software is not installed correctly, re-install it using swinstall. 12 Chapter 1