HP AE326A HP StorageWorks 1500 Modular Smart Array installation guide (355901 - Page 54
Read the messages on the controller display panel, Table 9 MSA1500 startup messages
UPC - 882780184954
View all HP AE326A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 54 highlights
Read the messages on the controller display panel Each controller contains an integrated LCD panel. This panel displays informational and error messages, shows the current status of the MSA, and provides an interface for user input. To verify that your MSA is operating properly, use the arrow buttons on the LCD panel of the controller and look for the following messages: Table 9 MSA1500 startup messages Message Startup Complete Fibre Sub-System Link Failure Array controller Firmware ver Meaning The array controller has completed its power-on sequence and is operational. No active fiber connection to the MSA controller exists. This message is expected, because, although you have physically installed the HBA in the server, you have not yet installed the drivers for the HBA and the MSA. You may safely ignore this message. The current version of the firmware running on the controller. If the Startup Complete message is not displayed: • Check the cable connections to the MSA • Check the availability of your power source • Review the setup instructions in the previous sections of this guide • Refer to the HP StorageWorks 1500 Modular Smart Array maintenance and service guide, available on the Documentation CD and the Technical documents page of the MSA1500 website: http://www.hp.com/go/msa1500cs. Go to Table 12: "MSA1500 information" on page 108 to record the controller firmware version. Verify the operating status of the storage enclosures To verify that your storage enclosures and hard drives are operating properly, view the enclosure and hard drive LEDs and compare them with the patterns described in the documentation for these devices. If the LEDs indicate a fault, see the documentation that came with the enclosure for help. 54 Installation procedures-All deployments