HP AJ765A HP StorageWorks RDX Removable Disk Backup System User Guide (484933- - Page 29

Power LED Table 3 Power LED LED Status OFF Steady GREEN Blinking GREEN Steady AMBER Blinking AMBER Meaning No power The drive is ready for operation Ejecting Fault Prevent Action required Check the power cable connection and replace the cable if necessary. You can use the power cable from your monitor or another device to check that the connection is working. If the power supply is present and the LED remains off, power cycle or reset the drive. If it still fails, call for service. None. This is normal. None. The unit is ejecting the cartridge. The unit has detected a fault condition. This may be because: • the unit cannot eject the cartridge due to an obstruction • the internal electronics are damaged or malfunctioning Use a straightened paper clip in the Emergency Eject Hole to remove a stuck cartridge, as described in "Emergency eject" on page 30. If this does not resolve the problem, run the RDX diagnostic application. None. The host server is accessing the media and the user has pressed the eject button. The unit will blink amber for a few seconds then return to steady green. Wait for host access to complete, after which the unit will eject the cartridge. If it does not, you may not be running the correct RDX utility, see "RDX Removable Disk utility" on page 12. Install the RDX utility and try again. If necessary, use Windows Explorer to eject the cartridge (right-click on the drive letter for the RDX Removable Disk Backup System and select Eject). RDX Removable Disk Backup System 29