HP AP775A Cisco MDS 9000 Family Command Reference Guide - Release 4.x (OL-1808 - Page 53

Chapter 1 CLI Overview Understanding CLI Command Hierarchy Send documentation comments to [email protected] write zone zoneset Write current configuration Execute Zone Server commands Execute zoneset commands Configuration Mode Options Configuration mode allows you to make changes to the existing configuration. When you save the configuration, these commands are preserved across switch reboots. Once you are in configuration mode, you can enter interface configuration mode, zone configuration mode, and a variety of protocol-specific modes. Configuration mode is the starting point for all configuration commands. When you are in configuration mode, the switch expects configuration commands from the user. The following example shows output from the config terminal command: switch# config terminal Enter configuration commands, one per line. End with CNTL/Z. switch(config)# Not all configuration mode commands that are available on the Cisco MDS 9000 Family are available on the Cisco Fabric Switch for HP c-Class BladeSystem and the Cisco Fabric Switch for IBM BladeCenter. The following two sections list the configuration mode commands for the Cisco MDS 9000 Family, the Cisco Fabric Switch for HP c-Class BladeSystem, and the Cisco Fabric Switch for IBM BladeCenter. Not all configuration mode commands that are supported on the Cisco MDS 9000 Family switches are available on the Cisco Fabric Switch for HP c-Class BladeSystem and the Cisco Fabric Switch for IBM BladeCenter. Configuration Mode Commands for the Cisco MDS 9000 Family switch# config terminal Enter configuration commands, one per line. End with CNTL/Z. switch(config)# ? Configure commands: aaa Configure aaa functions arp [no] remove an entry from the ARP cache banner Configure banner message boot Configure boot variables callhome Enter the callhome configuration mode cdp CDP Configuration parameters cfs CFS configuration commands cimserver Modify cimserver configuration cli CLI configuration commands clock Configure time-of-day clock cloud Configure Cloud Discovery cloud-discovery Configure Cloud Discovery crypto Set crypto settings device-alias Device-alias configuration commands do EXEC command dpvm Configure Dynamic Port Vsan Membership end Exit from configure mode exit Exit from configure mode fabric-binding Fabric Binding configuration fc-tunnel Configure fc-tunnel fcalias Fcalias configuration commands fcanalyzer Configure cisco fabric analyzer fcc Configure FC Congestion Control fcdomain Enter the fcdomain configuration mode fcdroplatency Configure switch or network latency OL-18089-01, Cisco MDS NX-OS Release 4.x Cisco MDS 9000 Family Command Reference 1-7