HP AP775A Cisco MDS 9100 Series Hardware Installation Guide (OL-17951-02, Febr - Page 41
Installing Front Rack-Mount Brackets for Cabinets with 26 Inches or Greater of Rail Spacings
UPC - 884962062708
View all HP AP775A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 41 highlights
Chapter 2 Installing the Cisco MDS 9100 Series Installing the Switch in a Cabinet with Insufficient Front Clearance Send documentation comments to [email protected] Installing Front Rack-Mount Brackets for Cabinets with 26 Inches or Greater of Rail Spacings The front rack-mount brackets for the Cisco MDS 9100 Series switch must be installed onto the switch prior to installing the switch into the cabinet. Follow these steps for cabinets with front-mounting rail to rear-mounting rail spacings greater or equal to 26 inches. Step 1 Step 2 Install the front rack-mount brackets as follows: a. Position one of the front rack-mount brackets against the side of the switch and align the screw holes as shown in Figure 2-8. Then attach the bracket to the switch with the three M4 screws originally provided with the bracket. b. Repeat with the other front-rack mount bracket on the other side of the switch. Install the C brackets as follows: Note Two C brackets are shipped preinstalled on the switch, using three M3 screws per bracket. This installation step is only necessary if the C brackets were removed. a. Position one of the C brackets against the side of the switch and align the screw holes as shown in Figure 2-8. Then attach the bracket to the switch with the three M3 screws originally provided with the bracket. b. Repeat with the other C bracket on the other side of the switch. Figure 2-8 Front Rack-Mount Brackets and C Brackets Installed on the Cisco MDS 9100 Series 96616 2 1 Front rack-mount bracket 1 2 C bracket OL-17951-02 Cisco MDS 9100 Series Hardware Installation Guide 2-13