HP AP775A Cisco MDS 9100 Series Hardware Installation Guide (OL-17951-02, Febr - Page 43
Installing Cisco MDS 9100 Series Switch Rear-Facing into Cabinet
UPC - 884962062708
View all HP AP775A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 43 highlights
Chapter 2 Installing the Cisco MDS 9100 Series Installing the Switch in a Cabinet with Insufficient Front Clearance Send documentation comments to [email protected] 1 Front rack-mount bracket 2 C bracket Installing Cisco MDS 9100 Series Switch Rear-Facing into Cabinet To install a Cisco MDS 9120 or 9140 Switch rear-facing into a cabinet using the rack-mount kit provided with the switch (for cabinets with insufficient front-facing clearance), follow the steps in this section. If you are installing a Cisco MDS 9134 Switch or a Cisco MDS 9124 Switch rear-facing into a cabinet using the rack-mount kit provided, see "Installing a Cisco MDS 9134 Switch or a Cisco MDS 9124 Switch Rear-Facing into Cabinet" section on page 2-17. Step 1 Install the slider rails in the rack: a. Position one of the slider rails against the front rack-mounting rails and align the screw holes as shown in Figure 2-10. Then attach them using two 12-24 screws or two 10-32 screws, depending on the rack rail thread type. For racks with square holes, first install the 12-24 cage nuts. b. Repeat with the other slider rail on the other front side of the rack. c. Use the tape measure and level to verify that the rails are horizontal and at the same height. Figure 2-10 Installing the Slider Rails to the Front Rack-Mounting Rails OL-17951-02 Rear cabinet mounting rails Front cabinet mounting rails 113428 Cisco MDS 9100 Series Hardware Installation Guide 2-15