HP AP775A Cisco MDS 9500 Series Hardware Installation Guide (OL-17467-02, Octo - Page 69
LEDs on IP Storage Services Modules, Cisco MDS 9000 Family IPS-4 Services Module
UPC - 884962062708
View all HP AP775A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 69 highlights
Chapter 1 Product Overview Services Modules Send documentation comments to [email protected]. Figure 1-30 shows the IPS-4 services module. Figure 1-30 Cisco MDS 9000 Family IPS-4 Services Module 2 113161 1 LINK 2 LINK 3 LINK 4 LINK 1 3 4 1 Status LED 2 Gigabit Ethernet ports 3 Link LEDs 4 Asset tag LEDs on IP Storage Services Modules Table 1-17 describes the LEDs for the IPS services modules. Table 1-17 LEDs for the Cisco MDS 9000 Family IPS Module LED Status Link Status Green Orange Red Solid green Flashing green Solid yellow Flashing yellow Off Description All diagnostics pass. The module is operational (normal initialization sequence). One of the following occurs or occurred: • The module is booting or running diagnostics (normal initialization sequence). • The inlet air temperature of the system exceeded the maximum system operating temperature limit (a minor environmental warning). To ensure maximum product life, you should immediately correct the environmental temperature and restore the system to normal operation. One of the following occurred: • The diagnostic test failed. The module is not operational because a fault occurred during the initialization sequence. • The inlet air temperature of the system exceeded the safe operating temperature limits of the card (a major environmental warning). The card shut down to prevent permanent damage. Link is up. Link is up (beacon used to identify port). Link is disabled by software. A fault condition exists. No link. OL-17467-02 Cisco MDS 9500 Series Hardware Installation Guide 1-47