HP Cisco MDS 9134 Cisco MDS 9000 Family Fabric Manager Configuration Guide, Re - Page 1247

Chapter 67 Configuring Port Tracking Port Tracking Send documentation comments to [email protected] Enabling Port Tracking The port tracking feature is disabled by default in all switches in the Cisco 9000 Family. When you enable this feature, port tracking is globally enabled for the entire switch. To configure port tracking, enable the port tracking feature and configure the linked port(s) for the tracked port. To enable port tracking with Fabric Manager, follow these steps: Step 1 Expand Switches, expand Interfaces, and then select Port Tracking in the Physical Attributes pane. The port tracking information is displayed in the Information pane shown in Figure 67-2. The default is the Controls tab. Figure 67-2 Port Tracking Step 2 Step 3 Click in the Command column to enable or disable port tracking. Depending on your selection the corresponding entry in the Status column changes. Click the Apply Changes icon to save your changes. The entry in the Result column changes to success. About Configuring Linked Ports You can link ports using one of two methods: • Operationally binding the linked port(s) to the tracked port (default). • Continuing to keep the linked port down forcefully-even if the tracked port has recovered from the link failure. Operationally Binding a Tracked Port When you configure the first tracked port, operational binding is automatically in effect. When you use this method, you have the option to monitor multiple ports or monitor ports in one VSAN. To operationally bind a tracked port, follow these steps: Step 1 Expand Switches, expand Interfaces, and then select Port Tracking in the Physical Attributes pane. The port tracking information is displayed in the Information pane. The default is the Controls tab. OL-16184-01, Cisco MDS SAN-OS Release 3.x Cisco MDS 9000 Family CLI Configuration Guide 67-3