HP Cisco MDS 9134 Cisco MDS 9000 Family Fabric Manager Configuration Guide, Re - Page 1319

Send documentation comments to [email protected] C A P P E N D I X Interface Nonoperational Reason Codes If the administrative state for an interface is up and the operational state is down, the reason code differs based on the nonoperational reason code as described in Table C-1. Table C-1 Reason Codes for Nonoperational States Reason Code Description Applicable Modes Link failure or not connected Physical layer link is not operational. All SFP not present The small form-factor pluggable (SFP) hardware is not plugged in. Initializing The physical layer link is operational and the protocol initialization is in progress. Reconfigure fabric in progress The fabric is currently being reconfigured. Offline Cisco MDS SAN-OS waits for the specified R_A_TOV time before retrying initialization. Inactive The interface VSAN is deleted or is in a suspended state. To make the interface operational, assign that port to a configured and active VSAN. Hardware failure A hardware failure is detected. Error disabled Error conditions require administrative attention. Interfaces may be error-disabled for various reasons. For example: • Configuration failure. • Incompatible buffer-to-buffer credit configuration. To make the interface operational, you must first fix the error conditions causing this state; and next, administratively shut down or enable the interface. OL-8007-10, Cisco MDS SAN-OS Release 3.x Cisco MDS 9000 Family Fabric Manager Configuration Guide C-1