HP Cisco MDS 9216A Cisco MDS 9000 Family System Messages Reference (OL-15956-0 - Page 239
show module internal all module, show module internal, all xbar <modulenumber>
View all HP Cisco MDS 9216A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 239 highlights
Chapter 2 System Messages and Recovery Procedures for the Cisco MDS 9000 Family Send documentation comments to [email protected] Introduced Cisco MDS SAN-OS Release 1.2(2a). Deprecated Cisco MDS SAN-OS Release 2.0(1b). Error Message MODULE-5-MOD_STARTUP_CFG_MISMATCH: The startup configuration cannot be applied to a different module type for module [dec] (serial: [chars]). [chars] module is replacing [chars]. Explanation The startup configuration for the module contains information about a different type of module instead of containing information about the current one. Recommended Action No action is required. Introduced Cisco MDS SAN-OS Release 1.2(2a). Error Message MODULE-5-MOD_WARNING: Module [dec] reported warnings on ports [dec]/[dec]-[dec]/[dec] ([chars]) due to [chars] in device [dec] (error [hex]). Explanation Module [dec] reported a warning in the runtime diagnostic because the failure of some of the ports. Recommended Action Collect module information by entering the show module internal all module [dec] command or by using a similar Fabric Manager procedure. Introduced Cisco MDS SAN-OS Release 1.2(2a). Deprecated Cisco MDS SAN-OS Release 2.0(1b). Error Message MODULE-5-STANDBY_SUP_OK: Supervisor [dec] is standby. Explanation Module is ready to be configured and to switch traffic. Recommended Action No action is required. Introduced Cisco MDS SAN-OS Release 1.2(2a). OL-15956-01 Error Message MODULE-5-XBAR_OK: Xbar [dec] is online (serial: [chars]). Explanation Xbar is ready to be configured and to switch traffic. Recommended Action No action is required. Introduced Cisco MDS SAN-OS Release 3.0(1). Error Message MODULE-5-XBAR_REINIT: Re-initializing xbar [dec] (serial: [chars]). Explanation Xbar reported a failure during the initialization phase and will be rebooted. Recommended Action Collect information about the module by issuing the show module internal all xbar CLI command or by using a similar Fabric Manager procedure. Introduced Cisco MDS SAN-OS Release 3.0(1). Cisco MDS 9000 Family System Messages Reference 2-203