HP Cluster Platform Introduction v2010 HP Cluster Platform Core Components Ove - Page 42
Rear View of the ProCurve 2848 Switch, HP ProCurve Switch 2848 Front View
View all HP Cluster Platform Introduction v2010 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 42 highlights
Figure 2-13 HP ProCurve Switch 2848 Front View 13 5 Use only one (T or M) for each port Power Fault hp P roCurve Switch 2848 J4904A 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 Status Lnk LED RPS Mode Act Fan FDx Test Spd Reset Clear Spd Mode off = 10Mbps flash = 100Mbps on = 1000Mbps 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 M 45 T M 46 T M 47 T M 48 T Dual Personality Ports 10/100/1000-t(T) or Mini-GBIC(M) 2 4 6 7 1. Power and Fault LEDs 2. Reset and Clear buttons 3. Test and Fan status LEDs 4. Port LED view select button and indicator LEDs 5. Switch port LEDs 6. 10/100Base-TX RJ-45 ports 7. Dual-personality ports (1000Base-T or mini-GBIC) 2.6.4.2 Rear View of the ProCurve 2848 Switch The HP ProCurve 2848 switch has a power connector, but it does not have a power switch. It is powered on when connected to an active AC power source. The switch automatically adjusts to any voltage between 100 volts and 240 volts (50-60 Hz). No voltage range settings are required. When the switch is powered on, it performs a diagnostic self-test that takes about 50 seconds to complete. The console port on the back of the ProCurve 2848 switch (Figure 2-14 "HP ProCurve Switch 2848 Rear View") connects the switch to a console via a serial cable. The console can be a PC or a workstation running a VT-100 terminal emulator. The RPS slot allows you to connect the ProCurve 2848 to a redundant power supply unit (optional). Figure 2-14 HP ProCurve Switch 2848 Rear View 1 2 34 1. Console port 2. Cooling vents 3. Redundant Power Supply (RPS) input 4. AC power connector The rear panel also has cooling vents, which must not be obstructed for proper switch operation. 42 Platform Core Components