HP DL320 HP ProLiant DL320 Generation 2 Server Setup and Installation Guide - Page 59
Connecting the Peripheral Device Cables and the Power Cord
UPC - 829160513218
View all HP DL320 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 59 highlights
Server Installation 4. At the rear of the rack, tighten the server thumbscrew that secures the fixed cable tray to the server. Figure 4-7: Securing the fixed cable tray to the server After installing the server in the rack, begin the procedure for "Connecting the Peripheral Device Cables and the Power Cord." Connecting the Peripheral Device Cables and the Power Cord WARNING: To reduce the risk of electrical shock or fire, do not plug telecommunications/telephone connectors into the NIC connectors. CAUTION: If the Remote Insight Lights-Out Edition II (RILOE II) is installed in the server, be sure that you attach the video cable to the video connector on the rear of the RILOE II board. The standard video connector on the server rear panel is not used when the RILOE II is installed. For more information, refer to the Remote Insight Lights-Out Edition II User Guide. Use the following figure and table to identify connectors and the order for connecting them. Connect the power cord last. 4-8 HP ProLiant DL320 Generation 2 Server Setup and Installation Guide