HP DesignJet 2000 HP DesignJet 2500/2000CP Printer - User's Guide - Page 298
Pause, Message, Explanation and Action, Refilling XmXX s
View all HP DesignJet 2000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 298 highlights
Front-Panel Messages Message Explanations and Actions Message Explanation and Action STATUS Paused You have pressed the Pause key. The printer will remain paused until you press the Pause key again. Press the Pause key again when you are ready. STATUS Printing The printer is printing. Wait for the printing to complete. STATUS Printing (Special) The printer is printing with a special print mode controlled by your software rather than by the printer. Wait for the printing to complete. STATUS Processing The printer has received a file from your software and is processing it ready to print. Wait for the printing to complete. STATUS Ready The printer is ready to print. Send a file to the printer. STATUS Ready for media The printer is ready for you to load media. Load appropriate media. STATUS Receiving The printer has received data. Wait for further messages. STATUS Recovering printhds. The printer is recovering the printheads after an ink system replacement process (only for UV Pigmented inks), or you have initiated the printhead recovery procedure under Utilities / Service Tests/ Recover Printheads. Wait for the printhead recovery procedure to complete. STATUS Refilling XmXX s The printer is filling the printheads. (This message only applies to firmware revision levels A.02.08 or higher.) Wait for the process to complete. STATUS Returning printheads The ink system replacement process has been cancelled, and the printhead carriage is returning to its station at the right of the printer. Wait until the carriage is in position. STATUS Roll feed edge trim The printer is trimming the edge of roll media. Wait until the media has been trimmed. 12-20