HP DreamColor Z32x User Guide - Page 12

Installing the stand

Get HP DreamColor Z32x PDF manuals and user guides View all HP DreamColor Z32x manuals
Add to My Manuals
Save this manual to your list of manuals

Page 12 highlights

Installing the stand CAUTION: Do not touch the surface of the LCD panel. Pressure on the panel may cause non-uniformity of color or disorientation of the liquid crystals. If this occurs the screen will not recover to its normal condition. TIP: Consider the placement of the display, because the bezel might cause interfering reflections from surrounding light and bright surfaces. The display uses the HP Quick Release 2 for easy mounting of the monitor. To mount the panel onto the stand: 1. Lay the monitor panel face down on a flat surface covered by a clean, dry cloth. 2. Slide the top of the stand's mounting plate (1) under the upper lip of the recess in the back of the panel. 3. Lower the bottom of the stand's mounting plate (2) into the recess until it snaps into place. 4. The HP Quick Release 2 latch (3) pops up when the stand is locked in place. 6 Chapter 3 Setting up the monitor

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
Installing the stand
CAUTION:
Do not touch the surface of the LCD panel. Pressure on the panel may cause non-uniformity of
color or disorientation of the liquid crystals. If this occurs the screen will not recover to its normal condition.
TIP:
Consider the placement of the display, because the bezel might cause interfering reflections from
surrounding light and bright surfaces.
The display uses the HP Quick Release 2 for easy mounting of the monitor. To mount the panel onto the
stand:
1.
Lay the monitor panel face down on a flat surface covered by a clean, dry cloth.
2.
Slide the top of the stand's mounting plate (1) under the upper lip of the recess in the back of the panel.
3.
Lower the bottom of the stand's mounting plate (2) into the recess until it snaps into place.
4.
The HP Quick Release 2 latch (3) pops up when the stand is locked in place.
6
Chapter 3
Setting up the monitor