HP J3111A HP JetDirect Print Servers 600N/400N/500X/300X Administrator's Guide - Page 121
Table 7.4, DLC/LLC Configuration Messages, General HP JetDirect Messages 1 of 15 - duplex
UPC - 002421211157
View all HP J3111A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 121 highlights
Table 7.4 DLC/LLC Configuration Messages Message DLC/LLC STATUS: SERVER ADDRESS: Description Current DLC/LLC status: DISABLED: Indicates that DLC/LLC was manually disabled through the printer's control panel (if available). DISABLED: Indicates that LAN Server was manually disabled through the printer's control panel (if available). READY: Indicates the HP JetDirect print server is awaiting data. NOT IN USE: Code is in the middle of a download. Station address of the remote end of the connection. Table 7.5 General HP JetDirect Messages (1 of 15) Message ARP DUPLICATE IP ADDRESS AUTONEGOTIATION ON OFF AUTO-REMOVAL ERROR BABBLE ERROR BAD BOOTP REPLY Description The ARP layer has detected another node on the network using the same IP address as the HP JetDirect print server. Extended error information below this message shows the hardware address of the other node. Identifies whether IEEE 802.3 Autonegotiation on the HP JetDirect 10/100TX port is enabled (ON) or disabled (OFF). If ON, the HP JetDirect print server will attempt to automatically configure itself onto the network at the proper speed (10 or 100 Mbps) and mode (half or full duplex). If OFF, you must manually configure the speed and mode using switches or jumpers on the print server. The HP JetDirect print server detected an internal hardware error following the Token Ring beacon auto-removal process and has removed itself from the ring. Run the power-on self-test: turn the printer off, then on again. If the error persists, replace the HP JetDirect print server. For information on replacing your HP JetDirect print server, see the hardware installation guide for your print server. An error was detected in the BOOTP reply that the HP JetDirect print server received. The BOOTP reply either had insufficient data in the UDP datagram to contain the minimum BOOTP header of 236 bytes, had an operation field that was not BOOTPREPLY(0X02), had a header field that did not match the print servers hardware address, or had a UDP source port that was not the BOOTP server port (67/udp). EN HP JetDirect Configuration Page Messages 115