HP Jetdirect 280m HP Jetdirect 200m Print Server - (English) Administrator Gui - Page 112
Network Settings, Apply, 11b Wireless Ethernet, Cancel, Reset to defaults, Use Wizard
View all HP Jetdirect 280m manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 112 highlights
Network Settings The Network Settings pages allow you to set or change configuration parameters for 802.11b (Wireless Ethernet), TCP/IP, IPX/SPX, AppleTalk, DLC/LLC, and SNMP protocols. To assign a parameter setting, enter the desired value and click Apply. 802.11b (Wireless Ethernet) The 802.11b pages allow you to create or change your wireless network configuration parameters for your IEEE 802.11b wireless ethernet connection. The configuration parameters are summarized in Table 4.3. For more information on setting up your HP Jetdirect wireless print server, see Appendix B. The 802.11b tab displays a single, static page that contains all wireless configuration parameters required to make a wireless connection to your network. Click Apply to set or Cancel to ignore your configuration entries. To reset to factory-default values, click Reset to defaults. Alternatively, you may choose to click the Use Wizard button at the top of the 802.11b page to configure your wireless network connection. This button will launch a configuration wizard that will guide you through the required 802.11b wireless configuration parameters and, depending on your choices, will bypass unnecessary parameters. Note If you improperly exit the wizard (for example, by failing to use the Cancel button), an Operation Failed screen may appear. If so, wait approximately two minutes before entering the wizard again. ENWW Using the Embedded Web Server 112