HP Jetdirect 280m HP Jetdirect 200m Print Server - (English) Administrator Gui - Page 196
HP LaserJet Utility., is 9100. HP Jetdirect
View all HP Jetdirect 280m manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 196 highlights
7. Is your protocol enabled on the HP Jetdirect print server? Check the status of your protocol on the Jetdirect configuration page. See Chapter 9 for information on the configuration page. (On TCP/IP networks, you can also use the embedded Web server to check status of other protocols. See Chapter 4.) 8. Is there an error message in the protocol's section on the Jetdirect configuration page? See Chapter 9 "HP Jetdirect Configuration Page" for a list of error messages. 9. If you are using Token Ring, is the data rate correct? Check the Jetdirect configuration page for the current settings. If they are incorrect, refer to the Token Ring settings in the print server hardware installation guide. 10. If you are using Apple EtherTalk, does the printer appear in the Chooser? Verify network and HP Jetdirect settings on the Jetdirect configuration page. See Chapter 9 for information on the configuration page. Confirm the network settings for the printer using the printer control panel (for printers with control panels). See the troubleshooting section in the online help for the HP LaserJet Utility. Verify the printer has the PostScript option installed. 11. If you are on a TCP/IP network, can you use Telnet to print directly to the printer? Use the following Telnet command: telnet where is the IP address assigned to the HP Jetdirect print server and is 9100. (HP Jetdirect data port 9101 or 9102 can also be used for ports 2 or 3 respectively, of a Jetdirect multiport external print server.) In the Telnet session, type in data and press Enter. The data should print to the printer (a manual form feed may be required). ENWW Troubleshooting the HP Jetdirect Print Server 196