HP L5015tm User Guide - Page 14
Mounting the monitor, VESA mounting
View all HP L5015tm manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
Mounting the monitor VESA mounting If you are mounting the panel to a wall or other mounting fixture, you must remove the monitor stand from the panel. The monitor has four mounting holes on the back side of the panel that adheres to the VESA mounting standard. CAUTION: This monitor supports the VESA industry standard 75mm mounting holes. To attach a third party mounting solution to the monitor, four 4mm, 0.7 pitch, and 10mm long screws are required (not provided with the monitor). Longer screws should not be used because they may damage the monitor. It is important to verify that the manufacturer's mounting solution is compliant with the VESA standard and is rated to support the weight of the monitor display panel. For best performance, it is important to use the power and video cable provided with the monitor. To remove the stand and mount the panel: 1. Turn off the monitor and computer. 2. Disconnect the power, USB, and video cables from the monitor and the computer. 3. Lay the monitor face down on a flat surface covered with soft protective cloth. 4. Using a Phillips screwdriver, remove the two screws that secure the stand to the back of the monitor. 5. Follow the instructions from the manufacturer to install the panel to the manufacturer's mounting fixture. 6. Reconnect the power, USB, and video cables to the monitor and the computer. 7. Turn on the computer, then turn on the monitor. NOTE: A filler plate is included with the monitor to use with the VESA mount. 8 Chapter 3 Setting up the monitor