HP L6010 L6010 Retail Monitor User Guide - Page 10
Setting Up the Monitor, Removing the Mounting Screws
View all HP L6010 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
2. To allow access to the mounting screws, remove the two plugs in the center of the stand by pinching together the tabs on the back of the plugs (1) then pulling the plugs out of the front of the stand (2). Figure 2-4 Removing the Access Plugs 3. Place the monitor face down on a flat surface covered with a clean, dry cloth and remove the four Phillips mounting screws from the rear of the monitor. Figure 2-5 Removing the Mounting Screws 4 Chapter 2 Setting Up the Monitor
2.
To allow access to the mounting screws, remove the two plugs in the center of the stand by
pinching together the tabs on the back of the plugs (1) then pulling the plugs out of the front of
the stand (2).
Figure 2-4
Removing the Access Plugs
3.
Place the monitor face down on a flat surface covered with a clean, dry cloth and remove the
four Phillips mounting screws from the rear of the monitor.
Figure 2-5
Removing the Mounting Screws
4
Chapter 2
Setting Up the Monitor