HP L6010 L6010 Retail Monitor User Guide - Page 18

Adjusting the Optional Monitor Stand For viewing clarity, adjust the monitor forward (up to -5 degrees) or backward (up to +35 degrees). Figure 2-20 Adjusting the Tilt Mounting the Monitor The monitor panel can be attached to a wall, swing arm, or other mounting fixture. NOTE: This apparatus is intended to be supported by UL or CSA Listed wall mount bracket. 1. Remove the four screws from the VESA mounting holes on the back of the monitor. CAUTION: This monitor supports the VESA industry standard 75mm mounting holes. To attach a third-party mounting solution to the monitor, four 4 mm, 0.7 pitch, and 10 mm long screws are required. Longer screws must not be used because they may damage the monitor. It is important to verify that the manufacturer's mounting solution is compliant with the VESA standard and is rated to support the weight of the monitor display panel. For best performance, it is important to use the power and video cables provided with the monitor. 2. To attach the monitor to a mounting fixture, insert the four screws that were previously removed through the holes on the mounting fixture and into the mounting screw holes on the monitor. Follow the manufacturer's documentation provided with the mounting fixture for additional assembly instructions. 3. Connect the required cables to the monitor panel and PC. Connecting the Cables NOTE: If the monitor is attached to the optional stand, route the cables through the stand as described in Attaching the Optional Monitor Stand in the Low-Mount Position on page 3 or Attaching the Optional Monitor Stand in the High-Mount Position on page 7. 1. Place the monitor in a convenient, well-ventilated location near the computer. 12 Chapter 2 Setting Up the Monitor