HP LC2000r Pedestal-to-Rack Conversion Guide - Page 36
Install Chassis Retention Bracket when Shipping an HP Rack
View all HP LC2000r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 36 highlights
Chapter 3 Conversion: Install Components, Cover, and Front Bezel Install Chassis Retention Bracket when Shipping an HP Rack For the HP rack, the rack nuts for the chassis retention bracket were installed on the right rear rack column. For the HP rack, install the chassis retention bracket and secure the NetServer to it, as follows: 1. Position the bracket as shown in Figure 3-9. Right Rear Column of HP Rack Hole 13 above Base Line Rack Nuts Hole 9 above Base Line Chassis Retention Bracket Figure 3-9. Screw Bracket to Rack and NetServer (Shown for HP NetServer LH 3r; Number of Power Supply Modules May Vary) NOTE The Chassis Retention Bracket is only required for shipping the system in an HP rack. 2. Fasten the bracket to the rack with the two 10x32 screws. 3. Fasten the bracket to the NetServer with the two 6x32 screws. For the HP rack with an anti-tip foot, retract the anti-tip foot if other components will not be extended from the front of the rack. 32