HP P6000 HP StorageWorks disk enclosure fan interconnect board replacement ins - Page 1

HP StorageWorks Disk enclosure fan interconnect board replacement instructions About this document For the latest documentation, go to http://www.hp.com/support/ manuals, and select your product. The information contained herein is subject to change without notice. The only warranties for HP products and services are set forth in the express warranty statements accompanying such products and services. Nothing herein should be construed as constituting an additional warranty. HP shall not be liable for technical or editorial errors or omissions contained herein. WARRANTY STATEMENT: To obtain a copy of the warranty for this product, see the warranty information website: http://www.hp.com/ go/storagewarranty This document details the procedures for replacing a failed fan interconnect board in an HP storage enclosure. Before you begin Observe the following precautions when replacing a module. CAUTION: • Parts can be damaged by electrostatic discharge. Use proper anti-static protection. Refer to the documentation that shipped with your system for additional information. © Copyright 2009 Hewlett-Packard Development Company, L.P. First edition: June 2009 The information in this document is subject to change without notice. Printed in the US www.hp.com NOTE: Illustrations in this document may show modules or a chassis that differ from your device. However, replacement procedures are the same for all chassis that use this component. The interconnect board for each fan is located on the base of the disk enclosure chassis. See Figure 1 for the locations. *504222-001* Page 1