HP Q7493A User Manual - Page 204
Type In Tray X
View all HP Q7493A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 204 highlights
Control panel message 41.3 UNEXPECTED SIZE IN TRAY X For help press alternates with LOAD TRAY XX [TYPE] [SIZE] To use another tray press 41.5 UNEXPECTED TYPE IN TRAY X For help press alternates with LOAD TRAY XX [TYPE] [SIZE] To use another tray press 44.1 USB ACCESSORY ERROR For help press 49.XXXX PRINTER ERROR To continue turn off then on 50.X FUSER ERROR For help press Description Recommended action Media is loaded that is longer or shorter in the 1. feed direction than the size configured for the tray. If the incorrect size was selected, cancel the job or press to access help. OR 2. Press to select another tray. 3. Press and to step through the instructions. The printer senses a different media type in 1. If the incorrect type was selected, the media path than configured in the tray. cancel the job or press to access help. OR 2. Press to select another tray. 3. Press and to step through the instructions. This message appears when a connected USB accessory draws too much power. When this happens, the ACC port is disabled and printing stops. Press to see step by step information. A critical firmware error has occurred. 1. Turn the printer off then on. 2. If the message persists, contact HP Support at http://www.hp.com/ support/clj4700. A fuser error has occurred.The following are 1. specific fuser errors: 2. 50.1: A low fuser temperature error has occurred in the main thermistor. 3. 50.2: A fuser warm-up service error has occurred. Turn the printer off then on. Press and to step through the instructions. If the message persists, contact HP Support at http://www.hp.com/ support/clj4700. 50.3: A high fuser temperature error has occurred in the main thermistor. 50.6: An open fuser error has occurred. 50.7: A fuser pressure release mechanism failure has occurred. 188 Chapter 8 Problem solving ENWW