HP Scitex FB7600 Essential Health and Safety Instructions Rev.C - Page 42

Ventilation and Fume Extraction Exhaust Fan To prevent the accumulation of hazardous vapors, sufficient ventilation must be provided by the customer to exchange the air in the area surrounding the FB7600 printer. The FB7600 printer is equipped with a built in fume extraction system but nevertheless the customer must ensure that the site and, in particular, the area surrounding the FB7600 printer complies with all applicable local legislation and guidance relating to ventilation and HP recommends a minimum of 4 air changes per hour within a 4 meter area surrounding the printer. Detailed air ventilation designs are based on site specific information and equipment. The customer should consult a ventilation/fume extraction professional familiar with local workplace and environmental legislation and guidance. Reference Refer to the MSDS for information on the inks and constituents: http://www8.hp.com/us/en/hp-information/environment/msds-specs.html UV Blower The UV blower with its silencer is supplied with the FB7600 system. Fumes produced during the ink curing process as well as ozone and heat produce by the UV lamp should be extracted from the production area, using an adequate UV blower. The silencer dimensions: 12" (300 mm) diameter, 47.2" (1200 mm) length. The UV blower should be positions inside the building as far as possible from the printer. The maximum distance is 15 m (see on page 32). The customer should provide a 10" (250 mm) sealed rigid duct from the UV blower to the outside atmosphere (out of the building) or to the site central extraction system. 34 HP Scitex Industrial Presses Essential Health and Safety Instructions