HP SignagePlayer mp8000s Hardware Reference Guide - Page 27

Installing the New Optical Drive, Removing the Computer Access Panel, on Removing a Bezel Blank

Get HP SignagePlayer mp8000s PDF manuals and user guides View all HP SignagePlayer mp8000s manuals
Add to My Manuals
Save this manual to your list of manuals

Page 27 highlights

Installing the New Optical Drive NOTE: If you are installing an optical drive in a bay that did not previously have a drive in it, you must remove the access panel and the bezel blank covering the opening of the bay before proceeding. Follow the procedures in Removing the Computer Access Panel on page 9 and Removing a Bezel Blank on page 13. 1. Attach the release latch to the new optical drive. Refer to Preparing the New Optical Drive on page 20. 2. With the back of the optical drive facing the computer and the release latch on the inner side of the drive, align the drive with the opening in the front bezel. 3. Slide the optical drive through the front bezel all the way into the bay so that it locks in place (1), then connect the cable to the rear of the drive (2). Figure 2-13 Installing the Optical Drive 4. Replace the access panel. 5. If the computer was on a stand, replace the stand. 6. Reconnect the power cord and turn on the computer. 7. Lock any security devices that were disengaged when the computer cover or access panel was removed. Replacing the Optical Drive 21

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
Installing the New Optical Drive
NOTE:
If you are installing an optical drive in a bay that did not previously have a drive in it, you
must remove the access panel and the bezel blank covering the opening of the bay before proceeding.
Follow the procedures in
Removing the Computer Access Panel
on page
9
and
Removing a Bezel Blank
on page
13
.
1.
Attach the release latch to the new optical drive. Refer to
Preparing the New Optical Drive
on page
20
.
2.
With the back of the optical drive facing the computer and the release latch on the inner side of
the drive, align the drive with the opening in the front bezel.
3.
Slide the optical drive through the front bezel all the way into the bay so that it locks in place (1),
then connect the cable to the rear of the drive (2).
Figure 2-13
Installing the Optical Drive
4.
Replace the access panel.
5.
If the computer was on a stand, replace the stand.
6.
Reconnect the power cord and turn on the computer.
7.
Lock any security devices that were disengaged when the computer cover or access panel was
removed.
Replacing the Optical Drive
21