HP SignagePlayer mp8000s Hardware Reference Guide - Page 37
B-3, Removing a Coin Cell Battery Type 3
View all HP SignagePlayer mp8000s manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 37 highlights
Type 3 a. Pull back on the clip (1) that is holding the battery in place, and remove the battery (2). b. Insert the new battery and position the clip back into place. Figure B-3 Removing a Coin Cell Battery (Type 3) NOTE: After the battery has been replaced, use the following steps to complete this procedure. 9. Replace the access panel. 10. If the computer was on a stand, replace the stand. 11. Reconnect the power cord and turn on the computer. 12. Reset the date and time, your passwords, and any special system setups, using Computer Setup. 13. Lock any security devices that were disengaged when the computer cover or access panel was removed. 31
Type 3
a.
Pull back on the clip (1) that is holding the battery in place, and remove the battery (2).
b.
Insert the new battery and position the clip back into place.
Figure B-3
Removing a Coin Cell Battery (Type 3)
NOTE:
After the battery has been replaced, use the following steps to complete this procedure.
9.
Replace the access panel.
10.
If the computer was on a stand, replace the stand.
11.
Reconnect the power cord and turn on the computer.
12.
Reset the date and time, your passwords, and any special system setups, using Computer Setup.
13.
Lock any security devices that were disengaged when the computer cover or access panel was
removed.
31