HP StorageWorks 4/64 Brocade Fabric OS Message Reference Supporting Fabric OS - Page 143

12 EM-1058 EM-1058 Message , [EM-1058], ,, WARNING, , Switch gets reset: Probable Cause The switch is automatically reset due to known resetable transient errors, such as an application-specific integrated circuit.(ASIC) parity. error. Recommended Action No action is required if the switch does not reach the reset threshold for the switch/blade. If the reset threshold is reached on the switch/blade, the switch/blade will be faulted and should be replaced. Severity WARNING EM-1059 Message , [EM-1059], , FFDC, CRITICAL, , Incompatible unit in faulted. Probable Cause Indicates that a field-replaceable unit (FRU) inserted in the specified slot is not compatible with the switch software. The blade will not be used. Recommended Replace the blade. Make sure the replacement is compatible with your switch type. Action Severity CRITICAL EM-1060 Message , [EM-1060], ,, WARNING, , Stopping synchronization of the system due to blade incompatibility with software version on standby CP. Probable Cause A blade in the system is not supported by the release on the standby control processor (CP). Recommended Action Please remove all blades of this type or upgrade your standby CP. Once an appropriate action is taken, this CP must be rebooted or haSyncStart must be run successfully. Until this is done, the system will remain out of synchronization. Severity WARNING EM-1061 Message Probable Cause , [EM-1061], ,, WARNING, , Synchronization halted. Remove all blades of type or upgrade your standby CP, then reboot or run haSyncStart. A blade in the system is not supported by the release on the standby control processor (CP). Fabric OS Message Reference 91 53-1000600-01