HP StorageWorks 4/64 Brocade Fabric OS Message Reference Supporting Fabric OS - Page 504

71 SYSC-1003 SYSC-1003 Message , [SYSC-1003], , FFDC, CRITICAL, , Chassis config option is not supported by CP Blade with ID . Change the chassis configuration Probable Cause Indicates that on system startup, the option configuration file corresponding to the chassisConfig option read could not be found. This indicates that option is not supported on this platform running this version of the firmware. It could also indicate that the current option number could not be read from the chassis option storage device (the world-wide name (WWN) card). This message occurs only on the Brocade 24000 and 48000. Recommended Action As indicated in the message, run the chassisConfig command to change to one that is valid on this platform running this firmware. Note that the chassisConfig option 1 should be valid for all platforms running any valid firmware. Severity CRITICAL SYSC-1004 Message , [SYSC-1004], ,, INFO, , Daemon restart successful Probable Cause Indicates that a terminated daemon is restarted by system automatically. Recommended Use the supportSave command to gather troubleshooting data. No further action is required. Action Severity INFO SYSC-1005 Message , [SYSC-1005], ,, WARNING, , Daemon is not restarted (Reason: ) Probable Cause Indicates that a terminated daemon is not restarted, either due to restart limit is reached or restart action fails Recommended Use the supportSave command to gather troubleshooting data. Issue a reboot or haFailover Action command to recover the system and limit the traffic disruption. Severity WARNING 452 Fabric OS Message Reference 53-1000600-01