HP StorageWorks 4000s NAS 4000s and 9000s Release Notes - Page 24
StorageWorks NAS system.
View all HP StorageWorks 4000s manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
The default configuration is: Array A: Consists of two logical drives and two physical drives in slots 0 and 1. Logical Drive 1: Raid: 1 Size: 27555 MB Sectors: 32 Stripe Size: 256 Array Accelerator: Enabled Logical Drive 2: Raid: 1 Size: 7171 MB Sectors: 32 Stripe Size: 256 Array Accelerator: Enabled If the Array and Logical Drive configuration has been altered and the Quick Restore fails to work properly, use the Array Configuration Utility to configure the drives as described above. The Array Configuration Utility is available by booting the system with the SmartStart CD included with the HP StorageWorks NAS system. WARNING: Do not replace the Operating System drives with drives that were previously configured on another system. Replace bad drives ONLY with blank, non-configured drives. If necessary, install the drives in another system and use ACU to remove any previous configuration from the drives. 24 HP StorageWorks NAS 4000s and 9000s Release Notes