HP StorageWorks 8/80 Brocade Fabric OS Command Reference v6.3.0 (53-1001337-01 - Page 52
Display Port Groups and Member N_Ports., Using Fabric OS commands, Command, Availability
View all HP StorageWorks 8/80 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 52 highlights
2 ag Notes Operands • Configure and display Port Group policy. • Create or remove a Port group. • Enable or disable auto port configuration (APC) modes for a Port group. • Get or set timeout value for fabric name monitoring. • Display Port Groups and Member N_Ports. • Add or delete N_Ports in Port group. • Display all policies and their status. • Enable or disable auto port configuration (APC) policy. • Enable or disable preferred secondary N_Port policy. • Enable, disable, and manage advanced device security (ADS) policy. • Manage persistent ALPA mode. AG configuration changes are saved persistently as configuration keys. Use the portCfgNPort command to set a port as N_Port. When used without operands, this command displays the usage. The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in place. Refer to chapter 1, "Using Fabric OS commands" and Appendix A, "Command Availability" for details. AG is supported only on selected Brocade hardware platforms. Refer to the Access Gateway Administrator's Guide for Hardware support and AG configuration procedures. In non-AG mode, the only two actions available are --modeenable and --modeshow. This command has the following operands: --help Displays the command usage. --show Displays the current configuration of the Access Gateway. This includes all N_Ports and F_Ports that are currently online, failover and failback settings as well as any online F_Ports that are currently mapped to N_Ports. Failover and failback policies are displayed as enabled (1) or disabled (0). --modeshow Displays the current Access Gateway operating mode of the switch as either enabled or disabled. --modeenable Enables Access Gateway mode on a switch. Long distance mode settings should be cleared for all ports on the NPIV edge switch to which the AG is connected. Otherwise, the NPIV switch port displays the long distance port type along with the F_Port. --modedisable Disables Access Gateway mode on a switch. After AG mode is disabled, the switch reboots automatically and comes online with default zone access set to "No Access". In order to merge the switch to a fabric, set the default zone to "All Access" and disable/enable the E_Port. 22 Fabric OS Command Reference 53-1001337-01