HP StorageWorks 8/80 HP StorageWorks Fabric OS 6.1.0d release notes (5697-7681 - Page 20

Fabric OS 6.1.0b

Get HP StorageWorks 8/80 - SAN Switch PDF manuals and user guides View all HP StorageWorks 8/80 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 20 highlights

Fabric OS 6.1.0b fixes Table 8 lists defects closed in the Fabric OS 6.1.0b firmware release. Table 8 Fabric OS 6.1.0b closed defects Closed defect summary Solution I2C response failure and subsequent reset will occasionally result in DC Director fan fault errors. Fixed in Fabric OS 6.1.0b When running stressful SAK IRNDUP to CUP tests, user may observe Intermittent Channel Timeouts. Fixed in Fabric OS 6.1.0b In a FICON Extender environment in which a host path goes offline, the switch does not link time-out the F_Port. Fixed in Fabric OS 6.1.0b HP StorageWorks 400 Multi-protocol Router: If there are multiple Initiators fanned into a single FCIP fastwrite tape target, the tape may Fixed in Fabric OS 6.1.0b be marked prematurely as full. When physically replacing an N_Port device with an ISL in a soft zone configuration, a DC SAN Backbone Director panic occurs. Fixed in Fabric OS 6.1.0b Traffic Isolation failover policy reverts back to "disabled" from "enabled" after changing the port membership list. Fixed in Fabric OS 6.1.0b Potential timeouts and aborts during Device Discovery and CU busy processing when using FICON XRC Emulation. Fixed in Fabric OS 6.1.0b Integrated Routing with multiple ports in an EX_Port trunk, may not properly send an entire exchange on the same link. Fixed in Fabric OS 6.1.0b FICON CUP reports incorrect Director Size Code in Basic Sense and Sense ID data for HP StorageWorks 8/40 and 8/80 SAN Switches. Fixed in Fabric OS 6.1.0b FICON Channel continuously sends RRQ frames for approximately 20 seconds before aborting. Fixed in Fabric OS 6.1.0b If QoS and Diff Serv are enabled, some FCIP tunnels may not come online in the case of an 8 to 1 fan-in scenario. Fixed in Fabric OS 6.1.0b When the proxy device projected to the backbone has a translate domain of greater than 0x20, the router is not properly translating the ACC for a REC. Traffic is interrupted and the tape device fails. Fixed in Fabric OS 6.1.0b HP StorageWorks 8/80 SAN Switch fan module can be marked faulty after multiple and repeated removals/reinsertions. Fixed in Fabric OS 6.1.0b 20

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
Fabric OS 6.1.0b
fi
xes
Table 8
lists defects closed in the Fabric OS 6.1.0b
fi
rmware release.
Table 8 Fabric OS 6.1.0b closed defects
Closed defect summary
Solution
I2C response failure and subsequent reset will occasionally result
in DC Director fan fault errors.
Fixed in Fabric OS 6.1.0b
When running stressful SAK IRNDUP to CUP tests, user may observe
Intermittent Channel Timeouts.
Fixed in Fabric OS 6.1.0b
In a FICON Extender environment in which a host path goes of
fl
ine,
the switch does not link time-out the F_Port.
Fixed in Fabric OS 6.1.0b
HP StorageWorks 400 Multi-protocol Router: If there are multiple
Initiators fanned into a single FCIP fastwrite tape target, the tape may
be marked prematurely as full.
Fixed in Fabric OS 6.1.0b
When physically replacing an N_Port device with an ISL in a soft
zone con
fi
guration, a DC SAN Backbone Director panic occurs.
Fixed in Fabric OS 6.1.0b
Traf
fi
c Isolation failover policy reverts back to "disabled" from
"enabled" after changing the port membership list.
Fixed in Fabric OS 6.1.0b
Potential timeouts and aborts during Device Discovery and CU busy
processing when using FICON XRC Emulation.
Fixed in Fabric OS 6.1.0b
Integrated Routing with multiple ports in an EX_Port trunk, may not
properly send an entire exchange on the same link.
Fixed in Fabric OS 6.1.0b
FICON CUP reports incorrect Director Size Code in Basic Sense and
Sense ID data for HP StorageWorks 8/40 and 8/80 SAN Switches.
Fixed in Fabric OS 6.1.0b
FICON Channel continuously sends RRQ frames for approximately
20 seconds before aborting.
Fixed in Fabric OS 6.1.0b
If QoS and Diff Serv are enabled, some FCIP tunnels may not come
online in the case of an 8 to 1 fan-in scenario.
Fixed in Fabric OS 6.1.0b
When the proxy device projected to the backbone has a translate
domain of greater than 0x20, the router is not properly translating
the ACC for a REC. Traf
fi
c is interrupted and the tape device fails.
Fixed in Fabric OS 6.1.0b
HP StorageWorks 8/80 SAN Switch fan module can be marked
faulty after multiple and repeated removals/reinsertions.
Fixed in Fabric OS 6.1.0b
20