HP StorageWorks 8/80 HP StorageWorks Fabric OS 6.1.2b release notes (5697-0351 - Page 29

Very rare occurrence of a switch panic when supportsave reads invalid data on G_Pports without FC FastWrite enabled. Fixed in Fabric OS 6.1.2 After upgrading one CP from Fabric OS 5.1x to 5.3x, if the other CP Workaround: Make sure both CPs has not yet been upgraded and there is another evmd listening event, are upgraded together. the switch may panic. Fixed in Fabric OS 6.1.2 IFCCs are seen with class 2 ELS timeouts, due to F_RJT not being returned for class 2 RNID when source and destination are excluded by Fixed in Fabric OS 6.1.2 hard zoning. Reduced I/O seen in large fabric testing when core blade removal and insertion cycles are executed on 8-Gb directors. Fixed in Fabric OS 6.1.2 If an HP StorageWorks Multi-Protocol Router blade installed in a director fails to initialize (bad blade), it could cause the system to assert and reboot due to FastWrite attempting to configure. Fixed in Fabric OS 6.1.2 Switch panic can occur during a rare occurrence of a timed-out exchange being accessed. Fixed in Fabric OS 6.1.2 With default zoning set to All Access, a race condition may cause ACK frame with FC-type Extended Link to be dropped. Fixed in Fabric OS 6.1.2 RSCN transmitted by the switch did not transmit all the port IDs in the payload after HPF key on or off. Fixed in Fabric OS 6.1.2 New ARB (FF) protocol required to be fully compliant with the latest FC standard (FC-PI-4) for 8-Gb FC ports. Fixed in Fabric OS 6.1.2 The portcfgspeed command with ax option on a switch running Fabric OS 6.1.x returns Error: Invalid speed level. Fixed in Fabric OS 6.1.2 Occasionally during firmware upgrade process, the 1250 processor is still rebooting when FCR routes are being processed, which results in missing FCR routes and an inability to route traffic across VEX_Ports. This leads to I/O running through VEX_Ports to be dropped after firmware upgrade. Fixed in Fabric OS 6.1.2 Management server drops IPC message from CALD module causing it to wait indefinitely, leading to CALD queue full message. May cause problem with management application, but traffic still passes without any problem. Fixed in Fabric OS 6.1.2 The fabstateshow log wraps, overwriting useful fabstate data on the B-series switch when interoperating with McDATA switches. Fixed in Fabric OS 6.1.2 When failover occurs, password-less SCP cannot be used from the switch, because they are not copied during HA failover. SCP with passwords can be used. Fixed in Fabric OS 6.1.2 Access Gateways connected to McDATA switches (EOSc firmware) are not shown in DCFM. Fixed in Fabric OS 6.1.2 HP StorageWorks Fabric OS 6.1.2b release notes 29