HP Surestore 15 Slot with DLT4000 Digital Linear Tape SCSI-2 Drive and SCSI-3 - Page 172
Table 2-105, Tape Drive/ Library Flag Definitions, Displayed Message, Probable Cause
View all HP Surestore 15 Slot with DLT4000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 172 highlights
Library SCSI-3 Command Set Log Sense Command (4DH) Table 2-105 Tape Drive/ Library Flag Definitions No Flag Type Displayed Message Probable Cause 3 Library C Hardware C 4 Library C Hardware D The library has a hardware fault: 1. Close library door. -or2. Clear any tapes that may be blocking the picker path. 3. Reset the library by running "Recalibrate" from the front panel or by issuing a re-zero and initalize elements command over SCSI. 4. Restart the operation. Check the library user manual for device-specific instructions on resetting the device. The changer mechanism has a hardware fault that requires reset to recover. This flag is set anytime the changer needs to be recalibrated, when there is a mechanical fault, or when the door is open during operation. The library has a hardware fault: 1. Turn the library off and then on again. 2. Restart the operation. 3. If the problem persists, call library support. Check the library user manual for device-specific instructions on turning the device power on and off. The changer mechanism has a hardware fault that is not mechanically related or requires a power cycle to recover. This flag is set when an RTL error exit occurs; therefore, the TapeAlert log will not be available over the SCSI interface. The flag will be recorded in the event log when possible. 2- 128 Chapter 2