HP Surestore 64 FW 05.01.00 and SW 07.01.00 Director Release Notes (AA-RTDVC-T - Page 20

Director Properties Description May Be Incorrect, Description, Director Properties

Get HP Surestore 64 - Director Switch PDF manuals and user guides View all HP Surestore 64 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 20 highlights

Known Issues Director Properties Description May Be Incorrect The text shown in the Description field of the Director Properties panel for the Director 2/140 may be incorrect. It may show SAN Director 64. This has no effect on the operation of the Director 2/140. This is a user-configurable description for the director, and may be changed to whatever you want by choosing Configure > Identification using HAFM, or by choosing Configure > Director > Identification using the Embedded Web Server interface. IML is Required After Performing a Configuration Reset If a Reset Configuration is performed on a Director 2/140 to reset the director to factory configuration, an initial machine load (IML) is required to be performed to complete the process. This is done by pressing the white button on the front of either CTP card for more than three seconds. This can also be accomplished by turning the power to the Director 2/140 off and then back on. 20 Director Release Notes

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
Known Issues
20
Director Release Notes
Director Properties Description May Be Incorrect
The text shown in the
Description
field of the
Director Properties
panel for the
Director 2/140 may be incorrect. It may show
SAN Director 64
. This has no
effect on the operation of the Director 2/140.
This is a user-configurable
description for the director, and may be changed to whatever you want by
choosing
Configure > Identification
using HAFM, or by choosing
Configure >
Director > Identification
using the Embedded Web Server interface.
IML is Required After Performing a Configuration Reset
If a
Reset Configuration
is performed on a Director 2/140 to reset the director to
factory configuration, an initial machine load (IML) is required to be performed to
complete the process. This is done by pressing the white button on the front of
either CTP card for more than three seconds. This can also be accomplished by
turning the power to the Director 2/140 off and then back on.