HP t5335 HP t5325/t5335 Thin Clients Hardware Reference Guide - Page 14

Mounting the Thin Client, HP Quick Release

Get HP t5335 - Thin Client PDF manuals and user guides View all HP t5335 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 14 highlights

C Mounting the Thin Client HP Quick Release This thin client incorporates four mounting points on the bottom of the unit. These mounting points follow the VESA (Video Electronics Standards Association) standard, which provides industrystandard mounting interfaces for Flat Displays (FDs), such as flat panel monitors, flat displays, and flat TVs. The HP Quick Release connects to the VESA-standard mounting points, allowing you to mount the thin client in a variety of orientations. NOTE: When mounting to a thin client, use the 10 mm screws supplied with the HP Quick Release. Figure C-1 HP Quick Release To use the HP Quick Release: 1. Using four 10 mm screws included in the mounting device kit, attach one side of the HP Quick Release to the thin client as shown in the following illustration. Figure C-2 Connecting the HP Quick Release to the thin client 8 Appendix C Mounting the Thin Client ENWW

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
C
Mounting the Thin Client
HP Quick Release
This thin client incorporates four mounting points on the bottom of the unit. These mounting points
follow the VESA (Video Electronics Standards Association) standard, which provides industry-
standard mounting interfaces for Flat Displays (FDs), such as flat panel monitors, flat displays, and
flat TVs. The HP Quick Release connects to the VESA-standard mounting points, allowing you to
mount the thin client in a variety of orientations.
NOTE:
When mounting to a thin client, use the 10 mm screws supplied with the HP Quick Release.
Figure C-1
HP Quick Release
To use the HP Quick Release:
1.
Using four 10 mm screws included in the mounting device kit, attach one side of the HP Quick
Release to the thin client as shown in the following illustration.
Figure C-2
Connecting the HP Quick Release to the thin client
8
Appendix C
Mounting the Thin Client
ENWW