Hitachi CMP4121HDU Owners Guide - Page 19
Size Switching, Displaying Two Screens, Input Signal Screen Display, OPERATING INSTRUCTIONS
View all Hitachi CMP4121HDU manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
OPERATING INSTRUCTIONS (continued) RECALL button SIZE button PinP button VOL MUTE VOL AUTO PinP SIZE RECALL RGB 1 RGB 2 VIDEO 1 VIDEO 2 MENU RETURN ENTER ID ID SET RECALL button SIZE button Size Switching Each time the SIZE button of the remote control or the monitor is pressed, the screen display size (or display area) will change in sequence and the status will be displayed at the bottom of the screen. • During RGB signal input NORMAL FULL ZOOM1 REAL* ZOOM3 ZOOM2 • Some types of signals may not be able to switch as desired. * VGA and W-VGA only • During VIDEO signal input (when the optional video unit is attached) 4:3 PANORAMA MOVIE1 FULL MOVIE2 • Depending on the type of signal, in some cases it may not be possible to switch the size, or switching to some sizes may not be possible. Displaying Two Screens If the PinP button on the remote control is pressed when the optional video unit is installed, two screens will display. Activating the P-in-P mode from the RGB input screen Pressing the PinP button one time will display two screens. ŋ The speaker icon can be shifted left and right by pressing the and SELECT buttons; the audio of the video will be output from the R1 V1 side on which the speaker icon is located. ŋ The sub-screen can be selected with the VIDEO1 and VIDEO2 buttons from the status shown in the diagram to the right. ŋ Pressing the PinP button again will (Subscreen) cancel the two screen display. V1: Displays the VIDEO input signal of the sub-screen. Activating the P-in-P mode from the video input screen Pressing the PinP button one time will display two screens. • The speaker icon can be shifted left and right by pressing the and V1 V2 SELECT buttons; the audio of the video will be output from the side on which the speaker icon is located. • Pressing the PinP button again will increase the size of the screen. • Pressing the PinP button once again will cancel the two screen display. Refer to two screen table TIPS ŋ Even if the input of the horizontal / vertical synchronizing signal (or video signal) stops in the two screen display, the mode will not change to power save mode. ŋ Please be careful since image retention will occur if display is left in a two screen display state for a long period of time. Input Signal Screen Display The input signal status can be displayed on the screen by pressing the RECALL button of the remote control. ŋ The display will go out in approximately 3 seconds. VIDEO VIDEO2 [COMPONENT] RGB Input terminal name RGB1 [RGB] H : 46.5kHz V : 60Hz Input horizontal frequency Input vertical frequency