Hitachi CMP4121HDU Owners Guide - Page 25

OPERATING INSTRUCTIONS (continued) DISPLAY MENU (continued) TIPS Using a wide-screen monitor • This monitor has a screen mode selection feature. If an incompatible screen mode is selected to play certain software, such as a TV program, the image would appear different from the original. Take this into consideration when making screen mode choices. • Use of this monitor in its enlarged display mode with the wide feature enabled in coffee shops, hotels and other establishments for commercial or pubic viewing purposes could infringe on the copyright holder's right protected by Copyright Law. • When a normal 4:3 image is displayed over the entire screen in the PANORAMA mode, not the Wide mode, parts of the periphery of the image may disappear and/or appear distorted in some cases. Use the 4:3 mode to view images, which were created in 4:3 mode. This mode allows 4:3 content to be viewed without picture distortion. FUNCTION MENU MENU ʬMAIN MENUʭ PICTURE SOUND DISPLAY FUNCTION OTHER SEL. ENT ENT. RTN END ENTER RGB ʬFUNCTION MENUʭ RGB1 SIGNAL : RGB RGB2 SIGNAL : RGB SEL. ADJ. RTN BACK ʬFUNCTION MENUʭ RGB1 SIGNAL : COMPONENT COMPONENT1 : AUTO RGB2 SIGNAL : RGB COMPONENT2 : AUTO SEL. ADJ. RTN BACK (This function can only be used when the optional video unit has been inserted.) h h h h h h @@@@@@@@@@ee ee ee ee ee ee ee ee ee ee ee ee ee ee ee ee ee ee ee ee ee ee ee VIDEO 1 ʬFUNCTION MENUʭ COLOR SYSTEM : AUTO 1 RGB VIDEO : OFF SEL. ADJ. RTN BACK VIDEO 2 ʬFUNCTION MENUʭ COMPONENT : AUTO SEL. ADJ. RTN BACK g g g g g g ee ee ee ee ee ee ee ee ee ee ee ee ee ee ee ee ee ee ee ee ee ee ee ee ee ee ee ee ee ee ee ee ee ee ee ee ee h h h h h hee ee ee ee ee ee ee ee ee ee ee ee ee ee ee ee ee ee g g g g g g ˛ ˛ Selected characters RGB1 SIGNAL (RGB2 SIGNALʣ COMPONENT (COMPONENT1, 2) RGB AUTO COMPONENT YCBCR YPBPR MUSE COLOR SYSTEM AUTO1 NTSC PAL SECAM N-PAL M-PAL 4-NTSC RGB VIDEO OFF ON Setup hint Sets to the signal output of the device to be connected to RGB I and RGB 2 jacks. Setup matching the color matrix format of the signal to be input. Switch the color system to suit the input system in video input mode VIDEO1. • Normally, set to AUTO1. The input signal system will be automatically recognized to display input images on the screen (NTSC, PAL, NTSC4.43). • If the input signal contains much noise or has a low level at AUTO1 and the operation is found erratic, set to match the input system. Compatible with European standard SCART signals. Inputs composite signals of video equipment to composite terminal and RGB signals of video equipment to connect R output to PR (CR) terminal, G output to Y terminal and B output to PB (CB) terminal. Normally set to OFF. * Cannot switch to VIDEO2 when ON is selected. ɿThis function can only be used when the optional video unit has been inserted.