Hitachi CPX605 User Manual - Page 16

Power on/off Power on/off Turning on the power 1. Make sure that the power cord is firmly and correctly connected to the projector and the outlet. STANDBY/ON button LASER INDICATOR 2. Remove the lens cover, and set the power switch to the ON position. STANDBY/ON VIDEO RGB BLANK LASER The power indicator will light up in steady orange (63). Then wait several seconds because the buttons may not function for these several seconds. ASPECT PUSH ENTER PAGE UP PAGE DOWN (1) When AUTO ON in OPTION menu is set to TURN ON (42) : ESC MENU RESET POSITION AUTO The lamp will only be automatically turned on when the Power switch is turned on after the power was turned off by MAGNIFY ON OFF FREEZE MY BUTTON 1 2 KEYSTONE VOLUME MUTE SEARCH Power switch last time. Afterwards the POWER indicator will begin blinking in green. When the power is completely on, the indicator will stop blinking and light in green. (2) When AUTO ON in the OPTION menu is set to TURN OFF (42): Please see step 3. 3. Press the STANDBY/ON button on the projector or the remote control. To display the picture, select an input signal according to the section "Selecting an input signal" (18). POWER indicator POWER (Steady orange) POWER (Blinking in green) POWER (Steady green) Turning off the power 1. Press the STANDBY/ON button on the projector or the remote control. The message "Power off?" will appear on the screen for about 5 seconds. 2. Press the STANDBY/ON button on the projector or the remote control again while the message appears. The projector lamp will go off, and the POWER indicator will begin blinking in orange. Power off? POWER (Blinking in orange) POWER Then the POWER indicator will stop blinking and light in steady (Steady orange) orange when the lamp cooling is complete. 3. Make sure that the power indicator lights in steady orange, and set the power switch to the OFF position. The POWER indicator will go off. Attach the lens cover. Do not turn the projector on for 10 minutes or more after turning it off. Turning the projector on again too soon could shorten the lifetime of some consumable parts of the projector. WARNING ►A strong light is emitted when the projector's power is on. Do not look into the lens of the projector or look inside of the projector through any of the projector's openings. ►Do not touch around the lamp cover and the exhaust vents during use or just after use, since it is too hot. NOTE • Turn the power on/off in right order. Please power on the projector prior to the connected devices. Power off the projector later than the connected devices. • Use the shutdown switch (65) only when the projector is not turned off by normal procedure. 16