Hitachi CPX605 User Manual - Page 29

IMAGE Menu IMAGE Menu From the IMAGE menu, items shown in the table below can be performed. Select an item using the ▲/▼ cursor buttons on the projector or remote control, and press the ► cursor button on the projector or remote control, or ENTER button on the remote control to execute the item. Then perform it according to the following table. /'07=4)$? 5'.'%6  2+%674' #52'%6 +/#)' 18'45%#0 +0276 8215+6+10 5'672 *215+6+10  #7&+1 *2*#5 5%4''0 *5 126+10 #761#&,756':'%76' 0'6914-  '#5;/'07 Item Description Using the ▲/▼ buttons switches the mode for aspect ratio. For an RGB signal NORMAL ó 4:3 ó 16:9 ó SMALL ASPECT For an M1-D signal NORMAL ó 4:3 ó 16:9 ó 14:9 ó SMALL For a Video signal, S-video signal or Component video signal 4:3 ó 16:9 ó 14:9 ó SMALL For no signal 4:3 (fixed) • The NORMAL mode keeps the original aspect ratio of the signal. OVER SCAN Using the ▲/▼ buttons adjusts the over-scan ratio. Large (It reduces picture) ó Small (It magnifies picture) • This item can be selected only for a video, s-video and component signal. • When this adjustment is too large, certain degradation may appear at the frame area of the picture. In such a case, please adjust small. V POSITION Using the ▲/▼ buttons adjusts the vertical position. Up ó Down • Over-adjusting the vertical position may cause noise to appear on the screen. If this occurs please reset the vertical position to the default setting. Pressing the RESET button when the V POSITION is selected will reset the V POSITION to the default setting. • When this function is performed on a video signal, s-video signal, or component video signal of 525i (480i) or 625i (576i), the range of this adjustment depends on the OVER SCAN (above) setting. It is not possible to adjust when the OVER SCAN is set to 10. H POSITION Using the ▲/▼ buttons adjusts the horizontal position. Left ó Right • Over-adjusting the horizontal position may cause noise to appear on the screen. If this occurs please reset the horizontal position to the default setting. Pressing the RESET button when the H POSITION is selected will reset the H POSITION to the default setting. • When this function is performed on a video signal, s-video signal, or component video signal of 525i (480i) or 625i (576i), the range of this adjustment depends on the OVER SCAN (above) setting. It is not possible to adjust when the OVER SCAN is set to 10. (continued on next page) 29