Hitachi CPX605 User Manual - Page 20
Adjusting the position, Correcting the keystone distortions
UPC - 050585150980
View all Hitachi CPX605 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
Operating ASPECT Adjusting the position PUSH ENTER 1. Press the POSITION button on the remote control. The "POSITION" indication will appear on the screen. PAGE UP ESC PAGE DOWN LASER MENU INDICATROERSET 2. Use the cursor buttons to adjust the picture position. STANDBY/ON VIDEO RGB POSITION AUTO MAGNIFY MY BUTTON VOLUME ON 1 When you want to reset the operation, press the RESET button on the remMoUTEte control during the operation. OFF FREEZE 2 KEYSTONE SEARCH BLANK LASER To complete this operation, press the POSITION button again. Even if you do not do anything, the dialog will automatically disappear after a few seconds. ● When this function is performed on a video signal, s-video signal or component video signal, some image such as an extra-line may appear at outside of the picture. ● When this function is performed on a video signal, s-video signal, or componeASnPECtT video signal of 525i (480i) or 625i (576i), the range of this adjustment depends on the OVER PUSHENTER SCAN in IMAGE menu (29) setting. It is not possible to adjust when the OVER SCAPNAGEUPis set to 10. PAGEDOWN Correcting the keystone distortions 1. Press the KEYSTONE button on the remote control. A dialog will appear on the -';5610' #761':'%76' screen to aid you in correcting the distortion. /#07#. 2. Use the cursor buttons ▲/▼ to select AUTO or MANUAL operation, and press the button ► to perform the following. ESC MENU RESET POSITION AUTO MAGNIFY ON OFF FREEZE MY BUTTON 1 2 KEYSTONE VOLUME MUTE SEARCH 1) AUTO executes automatic vertical keystone correction. 2) Manual displays a dialog for keystone correction. Use the cursor buttons ◄/► to select the direction to correct ( or ) then use the buttons ▲/▼ for adjustment. To close the dialog and complete this operation, press the KEYSTONE button again. Even if you don't do anything, the dialog will automatically disappear after a few seconds. -';5610' ● The adjustable range of this function will vary among inputs. For some input, this function may not work well. ● When V:INVERT or H&V:INVERT is selected to the MIRROR item in the SETUP menu, if the projector screen is inclined or angled downward, this function may not work correctly. ● When the zoom adjustment is set to the TELE (telephoto focus), this function may be excessive. This function should be used when the zoom adjustment is set to the full WIDE (wide-angle focus) whenever possible. ● When the projector is placed on the level (about ±3°), this function may not work. ● When the projector is inclined to near ±30 degree or over, this function may not work well. ● When the vertical lens shift is not set fully upward (not set fully downward for the optional lens type FL-601 only (45)), this function may not work well. ● When the horizontal lens shift is not set to the center, this function may not work well. ● This function will be unavailable when Transition Detector is on (51). 20