Hitachi X1250 User Manual - Page 15
Power ON/OFF - lamp
UPC - 050585150638
View all Hitachi X1250 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
Power ON/OFF WARNING • When the power is ON, a strong light is emitted. Do not look into the lens or vents of the projector. NOTE • Turn the power on/off in right order. Please power on the projector before the connected devices. Power off the projector after the connected devices. Turning On The Power 1 Remove the lens cap. STANDBY/ON STANDBY/ON button / indicator 2 Set the power switch to [ | ] (ON). The STANDBY/ON indicator will light to solid orange. 3 Press the STANDBY/ON button. The projector lamp will light up and the STANDBY/ON indicator will begin blinking green. When the power is completely on, the indicator will stop blinking and light green. 4 Use the LENS SHIFT buttons to shift the picture upward or downward. 5 Select an input signal according to the section "Selecting An Input Signal" of the following page. LENS SHIFT COMPONENTBNG S-VIDEO RGB M1-D INPUT INTER KEYSTONE SEARCH RESET VIDEO STANDBY/ON MENU TEMP LAMP FOCUS ZOOM AUDIO IN1 REMOTE CONTROL CONTROL NETWORK AUDIO IN2 RGB RGB OUT R/CR/PR G/Y B/CB/PB H V AUDIO OUT CR/PR Ca/Pa Y BNC R-AUDIO IN-L VIDEO S-VIDEO LASER INDICATOR STANDBY/ON VIDEO RGB STANDBY/ON +++ LENS SHIFT FOCUS ZOOM --- BLANK ASPECT LASER STANDBY/ON button Power switch (ON position) LENS SHIFT LASER INDICATOR STANDBY/ON VIDEO RGB ++ LENS SHIFT FOCUS -- + ZOOM - BLANK ASPECT LASER LENS SHIFT buttons LENS SHIFT COMPONENTBNG S-VIDEO RGB M1-D INPUT INTER KEYSTONE SEARCH RESET VIDEO STANDBY/ON MENU TEMP LAMP FOCUS ZOOM AUDIO IN1 REMOTE CONTROL CONTROL NETWORK AUDIO IN2 RGB RGB OUT R/CR/PR G/Y B/CB/PB H V AUDIO OUT CR/PR Ca/Pa Y BNC R-AUDIO IN-L VIDEO S-VIDEO Turning Off The Power 1 Press the STANDBY/ON button. The message "Power off?" will appear on the screen for approximately 5 seconds. STANDBY/ON STANDBY/ON button / indicator 2 Press the STANDBY/ON button again while "Power off?" the message is visible. The projector lamp will go off, and the STANDBY/ON indicator will begin blanking orange. Then the STANDBY/ON indicator will stop blinking LENS SHIFT COMPONENTBNG S-VIDEO RGB M1-D INPUT INTER KEYSTONE SEARCH RESET VIDEO STANDBY/ON MENU TEMP LAMP FOCUS ZOOM AUDIO IN1 REMOTE CONTROL CONTROL NETWORK AUDIO IN2 RGB RGB OUT AUDIO OUT CR/PR Ca/Pa Y R/CR/PR G/Y B/CB/PB H V BNC R-AUDIO IN-L VIDEO S-VIDEO LASER INDICATOR STANDBY/ON VIDEO RGB STANDBY/ON ++ LENS SHIFT FOCUS -- SC + ZOOM - S STANDBY/ON and light to solid orange when the lamp cooling is button complete. Power switch (OFF position) 3 Switch the power switch to [O] (OFF). The STANDBY/ON indicator will go off. 4 Attached the lens cap. 15