Homelite UT41121 User Manual - Page 15

Call Us First - line head

Get Homelite UT41121 PDF manuals and user guides View all Homelite UT41121 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 15 highlights

TROUBLESHOOTING PROBLEM POSSIBLE CAUSE SOLUTION Lines will not advance when 1. Lines are welded to themselves. using the auto feed head: 2. Not enough string on spool. 3. Lines are worn too short. 1. Lubricate with silicone spray. 2. Install more line. Refer to Line Replacement earlier in this manual. 3. Pull both lines while pressing button. 4. Lines are tangled on spool. 4. Remove lines from spool and rewind. Refer to Line Replacement earlier in this manual. Grass wraps around driveshaft 1. Cutting tall grass at ground level. housing and string head: 1. Cut tall grass from the top down to prevent wrapping. Motor fails to start when switch trigger is depressed. 1. Power cord is not plugged in or connection is loose. 2. Household circuit breaker is tripped. 1. Plug in the power cord. 2. Check circuit breaker. CALL www.homelite.com CALL US FIRST For any questions about operating or maintaining your product, call the Homelite® Help Line! Your product has been fully tested prior to shipment to ensure your complete satisfaction. Page 11 - English

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
Page 11 — English
TROUBLESHOOTING
1. Lubricate with silicone spray.
2. Install more line. Refer to
Line Replacement
earlier in this manual.
3. Pull both lines while pressing button.
4. Remove lines from spool and rewind. Refer to
Line Replacement
earlier in this manual.
1. Cut tall grass from the top down to prevent
wrapping.
1. Plug in the power cord.
2. Check circuit breaker.
1. Lines are welded to themselves.
2. Not enough string on spool.
3. Lines are worn too short.
4. Lines are tangled on spool.
1. Cutting tall grass at ground level.
1. Power cord is not plugged in or
connection is loose.
2. Household circuit breaker is
tripped.
Lines will not advance when
using the auto feed head:
Grass wraps around driveshaft
housing and string head:
Motor fails to start when
switch trigger is depressed.
PROBLEM
POSSIBLE CAUSE
SOLUTION
CALL
www.homelite.com
CALL US FIRST
For any questions about operating or maintaining your product,
call the Homelite
®
Help Line!
Your product has been fully tested prior to shipment to ensure
your complete satisfaction.