Homelite UT43122 User Manual - Page 25
Sharpening The Cutters, Warning, Caution
View all Homelite UT43122 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
MAINTENANCE SHARPENING THE CUTTERS See Figures 38 - 41. Be careful to file all cutters to the specified angles and to the same length, as fast cutting can only be obtained when all cutters are uniform. WARNING: Before performing any maintenance, make sure the tool is unplugged from the power supply. Failure to comply could result in accidental starting and possible serious personal injury. TOP PLATE CUTTING CORNER SIDE PLATE RIVET HOLE HEEL GULLET DEPTH GAUGE TOE Fig. 38 WARNING: The saw chain is very sharp. Always wear protective gloves when performing maintenance to the chain to prevent serious personal injury. n Tension the chain prior to sharpening. Refer to Adjusting The Chain Tension. n Use a 5/32 in. diameter round file and holder. Do all of your filing at the midpoint of the bar. n Keep the file level with the top plate of the tooth. Do not let the file dip or rock. n Using light but firm pressure. Stroke towards the front corner of the tooth. n Lift the file away from the steel on each return stroke. n Put a few firm strokes on every tooth. File all left hand cutters in one direction. Then move to the other side and file the right hand cutters in the opposite direction. n Remove filings from the file with a wire brush. CAUTION: A dull or improperly sharpened chain can cause excessive motor speed during cutting, which may result in severe motor damage. LEFT HAND CUTTERS RIGHT HAND CUTTERS Fig. 39 Fig. 40 Fig. 41 WARNING: Improper chain sharpening increases the potential of kickback, which could result in serious personal injury. WARNING: Failure to replace or repair a damaged chain could cause serious injury. Page 25 - English