Homelite UT44173 User Manual - Page 10
Operation, Assembly
View all Homelite UT44173 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
ASSEMBLY WARNING: If any parts are damaged or missing, do not operate this product until the parts are replaced. Use of this product with damaged or missing parts could result in serious personal injury. WARNING: Do not attempt to modify this product or create accessories not recommended for use with this product. Any such alteration or modification is misuse and could result in a hazardous condition leading to possible serious personal injury. ASSEMBLING THE SHRUBBER See Figure 5. To unlock bottom cover. Slide bottom cover latch to the right . Pull the bottom cover down to remove. To install blades: Install blades into the hole on the bottom of the shear. Place bottom cover slots onto tabs and slide close. Slide bottom cover latch left to lock. OPERATION WARNING: This battery powered shrubber is always in an operating condition and the blades can move if the switch trigger and lock-out button are pushed. The bottom cover latch should always be moved to the unlock (motor disabled) position when removing cut or jammed material from the blades, when changing blades or accessories, when transporting the shrubber, and when the shrubber is not in use. If the tool is left unattended, remove the blades and store them in a separate location out of the reach of children. Failure to follow these instructions could result in accidental or unauthorized starting of the grass shrubber and cause serious personal injury. WARNING: Do not allow familiarity with product to make you careless. Remember that a careless fraction of a second is sufficient to inflict serious injury. WARNING: Always wear eye protection with side shields marked to comply with ANSI Z87.1. Failure to do so could result in objects being thrown into your eyes, resulting in possible serious injury. WARNING: Do not use any attachments or accessories not recommended by the manufacturer of this product. The use of attachments or accessories not recommended can result in serious personal injury. APPLICATIONS You may use this product for the purpose listed below: n Trimming and shaping hedges and shrubbery CHARGING THE SHRUBBER See Figure 2. The internal battery in this tool has been shipped in a low charge condition to prevent possible problems. Therefore, you should charge it overnight prior to use. After each use, charge for at least 10 hours. To charge: Stop the motor. Insert charger plug into input jack making sure they are properly connected. Charger can be used with normal household voltage of 120 volts, AC only, 60 Hz. Connect charger to power supply. Do not place charger in an area of extreme heat or cold. It will work best at normal room temperature. Page 8 - English