Homelite UT46510 User Manual - Page 15
Adjustments, Operation
View all Homelite UT46510 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
OPERATION n Remove the hitch pins from the holes on the ends of the tine shaft. n Remove the outside tine blades and felt washers from the tine shaft. n Place hitch pins in the holes that were uncovered when felt washers were removed. NOTE: The unit will not operate properly if the tines are installed incorrectly. If you notice a problem with the cultivating operation of the unit, check for proper tine positioning. ADJUSTMENTS WARNING: To prevent accidental starting that could cause serious personal injury, always disconnect the cultivator from any power source when making adjustments. ADJUSTING WHEEL POSITION See Figure 12. The wheel position of the unit is adjustable. n Install the wheel/drag stake assembly in position A to transport the cultivator to and from the work area. n For general cultivating, remove the wheel/drag stake as- sembly to allow deep penetration of the tine blades into the cultivating surface. n The wheel/drag stake assembly may be installed in position B to allow use of the drag stake during cultivating. ADJUSTING CULTIVATOR SPEED AND DEPTH See Figure 13. The wheel/drag stake assembly may be used to help control the cultivator's speed and depth of operation. To adjust the height of the wheel/drag stake assembly: n Unscrew the adjustment knob and remove. n Adjust the wheel/drag stake assembly to the desired position. n To place the wheel/drag stake assembly in a deep position, insert the knob through the first hole. For a shallow position, insert the knob through the second or third hole. n Replace the adjustment knob. Tighten securely. Page 11 - English