Homelite UT80522A User Manual - Page 21

Troubleshooting

Page 21 highlights

TROUBLESHOOTING PROBLEM Engine fails to start CAUSE No fuel in tank Fill tank SOLUTION Water pressure in hose Squeeze trigger to relieve water pressure Spark plug shorted or fouled Replace spark plug Spark plug is broken (cracked porcelain Replace spark plug or electrodes broken) Ignition lead wire shorted, broken, or Replace lead wire or attach to spark plug disconnected from spark plug Engine hard to start Ignition inoperative Water in gasoline Contact authorized service center Drain entire system and refill with fresh fuel Engine lacks power Detergent fails to mix with spray Weak spark at spark plug Contact authorized service center Dirty air filter Clean or replace air filter Detergent injection hose is not properly Insert detergent injection hose into submerged detergent container or detergent bottle Pump doesn't produce pressure High pressure nozzle attached Low pressure nozzle installed Use blue soap nozzle to apply detergent Replace with high pressure nozzle Inadequate water supply Provide adequate water flow Trigger handle or spray wand leaks Check connections and / or replace trigger handle or spray wand Nozzle is clogged Clean nozzle Air in line Pull trigger on trigger handle to remove air from line Hose is leaking Replace hose Kink in hose Eliminate kinks in hose Choke in ON (START) position Move choke to OFF (RUN) position Pump is faulty Contact authorized service center Machine doesn't reach high pressure Diameter of garden hose is too small Replace with 3/4 in. garden hose Water supply is restricted Check garden hose for kinks, leaks, and blockages Not enough inlet water Open water source full force Wrong nozzle is attached Attach the high pressure nozzle Page 17 - English

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60

Page 17
— English
TROUBLESHOOTING
PROBLEM
CAUSE
SOLUTION
Engine fails to start
No fuel in tank
Water pressure in hose
Spark plug shorted or fouled
Spark plug is broken (cracked porcelain
or electrodes broken)
Ignition lead wire shorted, broken, or
disconnected from spark plug
Ignition inoperative
Fill tank
Squeeze trigger to relieve water pressure
Replace spark plug
Replace spark plug
Replace lead wire or attach to spark plug
Contact authorized service center
Engine hard to start
Water in gasoline
Weak spark at spark plug
Drain entire system and refill with
fresh
fuel
Contact authorized service center
Engine lacks power
Dirty air filter
Clean or replace air filter
Detergent fails to mix with spray
Detergent injection hose is not properly
submerged
High pressure nozzle attached
Insert detergent injection hose into
detergent container or detergent bottle
Use blue soap nozzle to apply detergent
Pump doesn’t produce pressure
Low pressure nozzle installed
Inadequate water supply
Trigger handle or spray wand leaks
Nozzle is clogged
Air in line
Hose is leaking
Kink in hose
Choke in ON (START) position
Pump is faulty
Replace with high pressure nozzle
Provide adequate water flow
Check connections and / or replace trigger
handle or spray wand
Clean nozzle
Pull trigger on trigger handle to remove
air from line
Replace hose
Eliminate kinks in hose
Move choke to OFF (RUN) position
Contact authorized service center
Machine doesn’t reach high pressure
Diameter of garden hose is too small
Water supply is restricted
Not enough inlet water
Wrong nozzle is attached
Replace with 3/4 in. garden hose
Check garden hose for kinks, leaks,
and
blockages
Open water source full force
Attach the high pressure nozzle