Homelite UT80993A User Manual - Page 17
Washing With Detergent, Rinsing With The Pressure Washer, Moving The Pressure Washer, Storing - pump
View all Homelite UT80993A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
OPERATION WASHING WITH DETERGENT See Figure 14 - 15. As sold, this unit is designed for use with "downstream" pressure washer detergents. To convert for use with "upstream" detergents, contact an authorized customer service center for more information. Use only detergents designed for pressure washers; household detergents, acids, alkalines, bleaches, solvents, flammable material, or industrial grade solutions can damage the pump. Many detergents may require mixing prior to use. Prepare cleaning solution as instructed on the solution bottle. Always test in an inconspicuous area before beginning. n Remove the cap from the detergent tank and pour pres- sure washer detergent in the tank. Replace cap on tank. NOTE: The machine setting of this unit is 20:1, which usually allows the use of 1 gallon pressure washer detergent without further dilution. Check your detergent instructions to be sure additional dilution is not necessary. n Install the blue soap nozzle on the spray wand. n Squeeze the trigger and wait approximately 5 seconds for the detergent to appear. n Spray the detergent on a dry surface using long, even, overlapping strokes. To prevent streaking, do not allow detergent to dry on the surface. Before shutting off the engine: n Fill the detergent tank with clean water. n Spray the clear water through the spray wand until the tank is empty. n If any soap remains in the spray, repeat with a second tank of clean water. n Shut off the engine. NOTE: Shutting OFF ( O ) the engine will not relieve pressure in the system. Pull trigger to release water pressure. RINSING WITH THE PRESSURE WASHER n Turn off the pressure washer and shut off the water supply. Pull trigger to release water pressure. n Engage the lock out on the trigger handle by pushing up on the lock out until it clicks into the slot. n Remove the nozzle by placing hand over nozzle then pulling back the quick-connect collar. Place nozzle in the nozzle storage area on the top of the machine. n Select the right nozzle for the job. See the chart on the previous page for selecting the appropriate nozzle. n Start at the top of the area to be rinsed and work down, overlapping the strokes. MOVING THE PRESSURE WASHER See Figure 16. NOTE: Never lift or carry this product using the handle. n Turn the pressure washer off. n Tilt the machine toward you slightly until it balances on the wheels then roll the machine to the desired position. Do not tilt forward or sideways when moving. STORING PRESSURE WASHER AFTER USE You must pull the trigger to release water pressure before attempting to disconnect the nozzle or high pressure hose for storage. Shutting off engine will not relieve pressure in the system. For long term storage, see Long-Term Storage of the Pressure Washer in the Maintenance section of this manual. Page 13 - English