Homelite UT80993A User Manual - Page 20

Troubleshooting - replacement pump

Page 20 highlights

TROUBLESHOOTING PROBLEM Engine fails to start CAUSE No fuel in tank Fill tank SOLUTION Water pressure in hose Squeeze trigger to relieve water pressure Spark plug shorted or fouled Replace spark plug Spark plug is broken (cracked porcelain Replace spark plug or electrodes broken) Ignition lead wire shorted, broken, or Replace lead wire or attach to spark plug disconnected from spark plug Engine hard to start Ignition inoperative Contact authorized service center Engine lacks power Weak spark at spark plug Dirty air filter Contact authorized service center Clean or replace air filter Detergent fails to mix with spray High pressure nozzle attached Use blue soap nozzle to apply detergent Detergent tank is empty Add detergent to detergent tank Pump doesn't produce pressure Low pressure nozzle installed Replace with high pressure nozzle Inadequate water supply Provide adequate water flow Trigger handle or spray wand leaks Check connections and / or replace trigger handle or spray wand Nozzle is clogged Clean nozzle Air in line Squeeze trigger on trigger handle to remove air from line Hose is leaking Replace hose Kink in hose Eliminate kinks in hose Choke in ON (START) position Move choke to OFF (RUN) position Pump is faulty Contact authorized service center Machine doesn't reach high Diameter of garden hose is too small ­pressure Water supply is restricted Not enough inlet water Wrong nozzle is attached Replace with 3/4 in. garden hose Check garden hose for kinks, leaks, and blockages Open water source full force Attach the high pressure nozzle Page 16 - English

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52

Page 16
— English
TROUBLESHOOTING
PROBLEM
CAUSE
SOLUTION
Engine fails to start
No fuel in tank
Water pressure in hose
Spark plug shorted or fouled
Spark plug is broken (cracked porcelain
or electrodes broken)
Ignition lead wire shorted, broken, or
disconnected from spark plug
Fill tank
Squeeze trigger to relieve water pressure
Replace spark plug
Replace spark plug
Replace lead wire or attach to spark plug
Engine hard to start
Ignition inoperative
Weak spark at spark plug
Contact authorized service center
Contact authorized service center
Engine lacks power
Dirty air filter
Clean or replace air filter
Detergent fails to mix with spray
High pressure nozzle attached
Detergent tank is empty
Use blue soap nozzle to apply detergent
Add detergent to detergent tank
Pump doesn’t produce pressure
Low pressure nozzle installed
Replace with high pressure nozzle
Inadequate water supply
Provide adequate water flow
Trigger handle or spray wand leaks
Check connections and / or replace trigger
handle or spray wand
Nozzle is clogged
Clean nozzle
Air in line
Hose is leaking
Kink in hose
Choke in ON (START) position
Pump is faulty
Squeeze trigger on trigger handle to remove
air from line
Replace hose
Eliminate kinks in hose
Move choke to OFF (RUN) position
Contact authorized service center
Machine doesn’t reach high
pressure
Diameter of garden hose is too small
Water supply is restricted
Not enough inlet water
Wrong nozzle is attached
Replace with 3/4 in. garden hose
Check garden hose for kinks, leaks, and
blockages
Open water source full force
Attach the high pressure nozzle