Honeywell #HZ-7000 Owners Manual - Page 2

BASIC CONTROL PANEL OPERATION: POWER Continuous Run MODE: SET TIMER Timer Power Mode Power F/C Mode • Press Mode until the Timer icon blinks. The Hour display will appear F/C • Use the Up or Down arrows to set an operation time between 1 and 10 hours. • The heater will turn-off when time runs out. • Press Power once to start the heater on High Power, Continuous Run. • Press Power again to change to Low Power, Continuous Run. FAHRENHEIT/CELSIUS • Press Power a third time to turn the heater off. Power MODE: SET TEMPERATURE Temperature Mode Power Mode F/C F/C Temperature Display F/C • Press Mode until the Temperature icon blinks. The current room temperature will appear. • Use the Up or Down arrows to set the desired temperature. • The Temperature icon will stop blinking and the current room temperature will reappear after the desired temperature is set. • The heater will turn-off shortly after the desired temperature is reached and the Power light above the display will blink. • The heater will turn back on when the room temperature drops approximately 2 degrees below the desired temperature. The Power light will stop blinking and will remain lit. • F/C feature functions from only the Power or Set Temperature screens. • Press the F/C button to toggle between Fahrenheit and Celsius. OSCILLATION (HZ-7020, HZ-7030, HZ-7040 SERIES) Power Mode Oscillation F/C • The Oscillation feature functions in any power or mode setting. • Press the Oscillation button to toggle this feature on and off. 2