Honeywell HW6200L Owners Manual - Page 21
Stopping Generator, Powering Appliances
UPC - 894190002124
View all Honeywell HW6200L manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
Stopping Generator Stopping Generator In an emergency: Press engine control switch to STOP position. In normal use: 1. Turn OFF any connected appliances and unplug any connected power cords. 2. Allow generator to run for 2-3 minutes. 3. Press engine control switch to STOP position. 4. Turn fuel shut-off valve to OFF position. For long-term storage instructions, see page 25. Powering Appliances NOTE: In this manual, the term "appliance" refers to any electrical device that can be connected to generator for power. Rules for Powering Appliances NOTICE NEVER start generator with electrical appliances plugged in and turned on. WARNING Faulty appliances and power cords can result in electrical shock. • Before attempting to power an appliance, be sure generator has been properly grounded, and the appliance and power cord are in good working order. • NEVER use generator for any purpose other than its intended use. • NEVER parallel connect generators or lengthen the exhaust pipe. • NEVER connect generator directly to any household receptacle using a power cord with male plugs at both ends. WARNING Medical and Life Support Uses • In case of emergency, call 911 immediately. • NEVER use this product to power life support devices or life support appliances. • NEVER use this product to power medical devices or medical appliances. • Inform your electricity provider immediately if you or anyone in your household depends on electrical equipment to live. • Inform your electrical provider immediately if a loss of power would cause you or anyone in your household to experience a medical emergency. • Plan carefully: Before using the generator to power appliances, take time to add power ratings (wattage) of each appliance and verify that total wattage does not exceed rated output of generator. Power rating information can usually be found on an appliance's product label, stamped inside, or on the back of the appliance. See Table 1 for a listing of average appliance wattage requirements. • NEVER overload: Circuit breakers will stop the flow of electricity from the generator to the appliance if the generator is overloaded. Check all circuit breakers for "tripped' position. If the master circuit breaker is tripped, reduce the load on the Twist-Lock (NEMA L14-30R) outlet. If a duplex outlet breaker is tripped, reduce the load on the duplex (NEMA 5-20R) outlet above the breaker, wait several minutes for the breaker to cool, and then push to reset. • Pay attention to appliance operation: If appliance begins to operate abnormally, becomes sluggish, or stops suddenly, turn it OFF immediately. Disconnect appliance and determine whether problem is appliance, or if rated load capacity of generator has been exceeded. • Use suitable extension cords: If using an extension cord to connect appliance to generator, use only ULlisted, three-prong extension cords. Be sure extension cord is proper size (wire-gauge) to handle electric load that will be plugged into it. CAUTION NEVER run power cords under carpet, rugs, or other materials where heat might build up or cord damage may go unnoticed. Appliance Wattage Information Use table below as a guide to determine how much power you will need to run appliances using generator. CAUTION The values provided in following table are estimates only. • ALWAYS verify actual wattage requirements for appliance you will be powering. Check labels inside or on the back of appliance, refer to appliance operating manuals, or contact appliance manufacturer. Appliance Typical Running Watts Air Conditioner, Central* 3500 Air Conditioner, Window* 500-1440 Aquarium 50-1210 Clock Radio 10 Coffee Maker 900-1200 TABLE 1. Typical Appliance Running Wattages HW6200/HW6200L Portable Electrical Generator Owner's Manual www.honeywellgenerators.com 15